Reset filter Export

___Part No.___ ______ (勾選方式)	___Features___	___Number of Channels___ ______ (勾選方式)	___Function___ ______ (勾選方式)	Vcc (V) Min (Range)	Vcc (V) Max (Range)	Icc (uA) TYP. (Range)	Icc (uA) Max (Range)	___VD (V)___ ______ (勾選方式)	___ID (mA)___ ______ (勾選方式)	___Vsub (V)___ ______ (勾選方式)	___Package___ ______ (勾選方式)
___L4002___	___4 Channels FET Bias Controller___ ______ ___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___ ___* Drive up to four FETs___ ___* 2.5V supply voltage___	___4___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	2.375	2.625	6	10	___2___	___9.5___	___-2___	___SOP-16___
___L8401___	___4 Channels FET Bias Controller___ ______ ___* Can Bias up to 4 FETs___ ___* Drain Current Adjustable by Two External Resistors.___ ___* Two Sets of Drain Current can be Setted.___	___4___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	3.3	6	-	10	___2___	___10___	___-2.5___	___SSOP-16(150mil)___
___L8402___	___4 Channels FET Bias Controller___ ______ ___* Can Bias up to 4 FETs___ ___* Wide supply voltage range: 3V~8V___ ___* Low quiescent supply current, 1.2mA typical___ ___* FET drain voltages set at 2.0V___ ___* Adjustable FET device operating current___ ___* FET drain voltages and currents held stable over temperature___ ___and VCC variations___ ___* Built in FET device protection circuit___ ___* Low external component count___	___4___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	3	8	1	4	___2___	___15___	___-2.65___	___QFN-16(3X3)___ ___SSOP-16___
___L8403___	___4 Stage FET LNA Bias Controller___ ______ ___* Provides Bias for up to 4 GaAs and HEMT FETs___ ___* Operating Range of 2.1V to 5V___ ___* Ultra-low Operating Current of 0.95mA___ ___* Dynamic FET Protection___ ___* Amplifier FET Drain Voltages set at 2.0V___ ___* Regulated Negative Rail Generator Requires only 1 External___ ___Capacitor___ ___* Expended Temperature Range of -40°C to +105°C___	___4___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	2.1	5	0.95	2	___2___	___10___	___-2.0___	___QFN-16(3X3)___
___L8600___	___6 Channels FET Bias Controller___ ______ ___* Can bias up to 6 FETs___ ___* Drain current adjustable by two external resistors.___ ___* Two sets of drain currents can be set.___	___6___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	5	12	-	15	___2.2___	___10___	___-3___	___SSOP-20(150mil)___
___L8602___	___6 Channels FET Bias Controller___ ______ ___* Low quiescent supply current, 1.6mA typical___ ___* Six stage FET bias controller, two configurable as mixer stages___ ___* Operating range of 3.0V to 8.0V___ ___* Amplifier FET drain voltages set at 2.0V, mixer drain voltage set___ ___at 0.25V___ ___* Amplifier FET drain current selectable from 0 to 15mA, mixer___ ___current from 0 to 7.5mA___ ___* Switchable FET’s for power management___ ___* FET drain voltages and currents held stable over temperature___ ___and VCC variations___ ___* FETs protected against overstress during power-up and___ ___power-down.___ ___* Internal negative supply generator allowing single supply___ ___operation (available for external use)___ ___* Low external component count___	___6___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	3	8	1.6	4	___2___	___10___	___-2.65___	___QFN-20(4X4)___
___L8001___	___6 Channels FET Bias Controller___ ______ ___* Built in FET device protection circuit___ ___* Adjustable FET device operating current___ ___* Stable bias control for GaAs and HEMT FETs___ ___* Drive up to six FETs___ ___* Wide supply voltage range___	___6___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	3.3	6	-	10	___2___	___10___	___-2.5___	___SSOP-20(150mil)___
___L8002___	___6 Channels FET Bias Controller___ ______ ___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___ ___* Drive up to six FETs___ ___* 2.5V supply voltage___	___6___	___* Built in FET device protection circuit___ ___* Stable bias control for GaAs and HEMT FETs___	2.375	2.625	6	10	___2___	___9.5___	___-2___	___SSOP-20(150mil)___
___L8020___	___Dual Polarsation Switch Twin LNB Multiper Controller___ ______ ___* Avoid external components___ ___* Provides polarity detection and control___ ___* Temperature compensated input threshold___ ___* Normal and inverted output available while wide supply operating range___ ___* Simplify the design___	___2___	___* Voltage detection___	5	12	-	10	___-___	___-___	___-___	___SOP-8___ ___MSOP-8___
___L8012___	___Dual Tone and Polarity Switch For LNB Multiper Controller___ ______ ___*Dual channels multiplexing with low external component counts.___	___2___	___* Voltage detection___ ___* 22kHz tone detector___	5	8	9	12	___-___	___-___	___-___	___SSOP-16(150mil)___
___L8312___	___Dual Polarization and Tone Switch Controller___ ______ ___* Direct Drive PIN Diode and Multiplexer IC___ ___* High Supply Voltage___	___2___	___* Voltage detection___ ___* 22kHz tone detector___	5	9	10	-	___-___	___-___	___-___	___SSOP-16___
___L8200/A___	___Single LNB-Bias, Control And Power Management Solution.___ ______ ___* Single chip LNB bias, control and power management___ ___* Integrated regulated supply for LNB___ ___* Zero Gate FET switching___ ___* Voltage detection for polarization switching___ ___* 22kHz tone detector with signal rejection for band switching___ ___* Programmable mixer and FET bias___	___4___	___* Integrated regulated supply for LNB___ ___* Voltage detection___ ___* 22kHz tone detector___ ___* Programmable mixer and FET bias___	8V	22V	2	3	___1.95___	___9.5___	___-2.4___	___TSSOP-16___ ___QFN-16(3x3)___
___L8211___	___3 Channels FET Bias Controller With Polarization Switch and Tone Detection___ ______ ___* Three outputs that can drive up to 3 FETs.___ ___* Drain current adjustable by external resistor.___ ___* HB and LB switch for LNBs.___ ___* Band switching by 22kHz tone detection.___	___3___	___* Three outputs that can drive up to 3 FETs___ ___* Voltage detection___ ___* 22kHz tone detector___	5	10	6	15	___2___	___10___	___-3___	___SSOP-20(150mil)___
___L8113___	___3 Channels FET Bias Controller With Polarization Switch and Tone Detection___ ______ ___* High-accuracy voltage detection circuit___ ___* Two types of cell-balance function: charge/discharge___ ___* Control charging, discharging, cell-balance by CTLC,CTLD pins___ ___* Low current consumption: 8.0μA max___	___3___	___* Three outputs that can drive up to 3 FETs___ ___* Voltage detection___ ___* 22kHz tone detector___	5	10	-	15	___2.2___	___10___	___-3___	___SSOP-20(150mil)___
___L8115___	___3 Channels FET Bias Controller With Polarization Switch and Tone Detection___ ______ ___* Can bias up to 3 FETs___ ___* HB and LB switch for LNBs.___ ___* Drain current adjustable by external resistors.___ ___* Band switching by 22KHz tone detection.___	___3___	___* Three outputs that can drive up to 3 FETs___ ___* Voltage detection___ ___* 22kHz tone detector___	5	10	8.5	15	___2.2___	___10___	___-2.8___	___SSOP-16(150mil)___ ___SSOP-20(150mil)___
___L8221___	___Single LNB–Bias, Control and Power Management Solution___ ______ ___* Single chip LNB bias, control and power management___ ___* 22kHz tone detector with signal rejection for band switching___ ___* Zero Gate FET switching___ ___* Voltage detection for polarization switching___ ___* Programmable mixer and FET bias___ ___* Temperature compensated protected FET bias___	___2___	___* Integrated regulated supply for LNB___ ___* Voltage detection___ ___* 22kHz tone detector___	8	22	2	3	___2___	___10___	___-2.5___	___HSOP-8___
___LB8102___	___DiSEqC Switch IC___ ______ ___* Single supply voltage 3.9V~5V.___ ___* Support DiSEqC 1.0/ 1.1 and Tone Burst commend___ ___* Selectable 4x1 and 2x1 application.___ ___* Drives up to four switches.___ ___* Position and option witch commend.___ ___* SOP8 surface mount package___	___4___	___* Support DiSEqC 1.0/ 1.1 and Tone Burst commend___	3.9	5.5	0.15	0.3	___-___	___-___	___-___	___SOP-8___